Temperature Setting - Kospel KDE series Bedienungsanleitung

• - air bubbles in the heating box - equipment detection,
ERR
AIR1
• - air bubbles in the heating box - program detection.
ERR
AIR2
If the display shows
The unit will not heat again until the failure is resolved and the appropriate rate of
water flow is reached.
If you try to set the temperature above the adjusted maximum value the display will
show .

Temperature setting

Display shows three icons:
value (which has been stored in memory for each icon) by pressing one of them
- the icons will be displayed in inverse
To change the desired temperature value:
• push the icon,
• push the icon again and keep (for about 3 seconds) until the value starts to flicker,
• to set the new value press
• to save the value press icon.
Notice: save the new value within 10 seconds, otherwise you will lose it.
Configuration
To enter the configuration mode press B . To adjust the value press
parameters will switch as you press
parameters:
• maximum temperature value,
• display contrast (0-20),
• display brightness in stand-by-mode (0-20) /brightness min. / (0 – brightness max.),
• display brightness in active mode (0-20) /brightness max. / (brightness min. –20).
To exit parameters setting mode press
automatically exit after 20 seconds since the last adjustment.
Parameters view
To enter the parameters view mode press A .The parameters will switch as you press
. You can switch between the following parameters:
• flow rate
• percentage of maximum power with which the unit currently heats
• rated power
• correction of power
• software details and work time,
• inlet temp
• outlet temp
26
ERR , ERR , ERR the unit will stop heating.
Tmax AIR1
AIR2
,
,
,
,
.
You can set the desired temperature
,
. You can switch between the following
Notice: parameters setting mode will
.
The
,