Transmitter - thomann the t.bone free solo HT 1.8 GHz Bedienungsanleitung

Attaching the antennas
Connecting audio and starting
up

4.3 Transmitter

Inserting batteries into the
receiver
Attach the included antennas to the rear panel of the transmitter. To improve the transmission
quality and to adapt to the spatial conditions they are rotatable and swivelling.
In case the space provided on the device for direct assembly of the antennas is not sufficient,
for example because the space on the rack is narrow, you can use the optionally available
coaxial cable to assemble the antennas separately from the device. For larger combinations
with up to four receivers, an antenna distributor is optionally available.
Connect one of the audio outputs of the receiver to your mixer or your amplifier. Ensure that
only one of the two outputs is ever used at a time, because faults might occur otherwise.
Unscrew the bottom housing section of the hand-held microphone. Insert the batteries. Pay
attention to the correct location of the poles. The correct arrangement of the batteries is indi‐
cated with symbols in the battery compartment. Close the battery compartment, screw the
bottom housing section back on, and switch the transmitter on.
free solo HT 1.8 GHz
Installation and operation
17