LANCOM CC series Erste Schritte Seite 19

Via the serial configuration interface
The serial configuration cable is included the LANCOM CC Start-up Kit.
LAN
ROUTER
1
Always switch on the device for configuration before you switch on
I
the computer.
...with LANconfig
LANconfig. Unconfigured LANCOM devices in local networks are
Start
detected automatically.
LANconfig may be unable to detect devices in the LAN if the "Internet
I
connection firewall" or any other personal firewall is activated on the
configuration computer. If your unconfigured device cannot be found,
deactivate the firewall for the time during which you carry out the
configuration.
The CC Start-up Wizard starts automatically. For detailed information
about the wizard and its operation see item
Network without a DHCP server
Find the current IP address of the configuration computer (with Start
cmd and enter the command ipconfig at the command prompt under
Windows XP, Windows Vista, Windows 7 or Windows 8). In this case, the
LANCOM can be accessed with address x.x.x.254 (the "x"s stand for the first
three blocks in the IP address of the configuration computer).
...via the serial interface
Connect the computer via the
duct the configuration with
LANCOM CC Routers
.
PC
Outband
ROUTER
2
serial configuration interface
or with a
LANconfig
First Steps
.
Run
and con-
terminal program.
5