Installing The Software - LANCOM CC series Erste Schritte

LANCOM CC Routers

Installing the software

Deploying and connecting the device
C
C
Configuring the devices...
A LANCOM router can be configured in the following ways:
4
First Steps
To carry out the configuration, please
When deploying/mounting the device
deployment, with particular regard to the environmental conditions,
stackability, etc., as outlined in the technical specifications in the
Reference Guide.
In the case of LANCOM UMTS/LTE devices,
if applicable.
antennas
Connect your PC to the
When connecting the Ethernet interfaces, please ensure that the two
devices being connected (e.g. switch and LANCOM) both have the
same setting for auto mode. If a LANCOM is connected to a switch
that does not support auto mode, or if this function has been deacti-
vated in the switch, then auto mode must also be deactivated in the
LANCOM (default = on). Contradictory settings can lead to data trans-
fer errors, either immediately or after some time (days). When com-
missioning the LANCOM, no additional devices are to be connected.
For this reason, when commissioning your LANCOM, it must be con-
nected directly to your PC.
Because DHCP is not permitted in CC-compliant operation, you must
assign a fixed IP address to your configuration computer.
Connect the device to the power supply
adapter unit or power cord) and switch on the power switch.
Via the local network (LAN) ³.
install LANconfig.
consider the instructions on
mount and connect any
of the LANCOM.
LAN port
Quick
(via the supplied power