Confirm Beep; Select Base; Language; Registration - Silvercrest SDT 1.7 A1 Bedienungsanleitung Und Serviceinformationen

SilverCrest SDT 1.7 A1

Confirm Beep

Press the  or  directional control buttons [4] to enable or disable the confirmation beep. To
save the selected setting, press the Phonebook button [3]. A confirmation beep will sound and the
"Saved" message will appear for a few seconds on the display [2].

Select Base

This allows you to select the base where you want to register a handset. As you will normally have
one base only, you can use the default setting "Auto". Where several bases are available, you can
use the "Manual" option to select the desired base manually from the list. Please note that the
handset must be located within RF range of the base.

Language

Set the language for the handset as follows:

Press the  or  directional control buttons [4] to select the desired language (e.g.
"English") from the list. The following languages are available: English, French, Spanish,
German and Italian.

Press the Phonebook button [3] to confirm your selection.

A confirmation beep will sound and the "Saved" message will appear for a few seconds
on the display [2].

Registration

Register
You can register up to 5 handsets with one base. By default, the handset supplied has already
been registered with the base (Base 1). To register a de-registered or a new handset with the base,
proceed as follows:
Notice for using handsets from different manufacturers
If you want to register third-party DECT handsets that support the GAP standard with
your SilverCrest base, please read the documentation of their manufacturers. However,
it cannot be guaranteed that third-party handsets will be fully compatible even when
using the GAP standard.

Press the  or  directional control buttons [4] on the handset to select the base from
the list to which you want to register the handset. Then press the Phonebook button [3].

Enter the phone's four-digit PIN code (default 0000) and press the Phonebook button [3]
to confirm.

The display [2] reads "Press & Hold Page Key On Base".
174 - English