Resetting The Handset; Everyday Use; Making Calls; External Calls - Silvercrest SDT 1.7 A1 Bedienungsanleitung Und Serviceinformationen

SilverCrest SDT 1.7 A1

Resetting the handset

You can restore the handset to its factory settings. Please note that this will erase all settings. To
reset the handset to the factory defaults, press and hold the Recall/Flash button ( ) of the
directional control [4] for at least 10 seconds. Press the Phonebook button [3] to confirm the safety
prompt, or press the Menu button [12] to cancel.

Everyday Use

Making calls

External calls

Use the numeric buttons [6] to enter a telephone number. After you have entered the phone
number, press the Dial button [11] to call the entered number.
Press the Menu button [12] to clear the entered phone digits step by step.
To reduce the volume during a call, press the
To increase the volume during a call, press the
[4]. The current volume level is shown on the display [2].

Calling a number from the phonebook

If you want to use a number stored in the phone book, press the Phonebook button [3] while in
standby mode. Press the  or  directional control buttons [4] to select the desired entry and then
press the Dial button [11] to call the selected entry.
Press the numeric keys [6] to enter a letter and display the entries beginning with
this letter.
Press the End call button [5] to hang up.
For more information about adding a new phone book entry, please read the
chapter "Phonebook" on page 169.

Internal calls

If you have registered multiple handsets with your base you can make internal calls. Press the INT
button on the directional control [4] to make an internal call. "Internal" will appear on the display
[2]. Next enter the number of the handset that you want to call. The connection will be established
immediately after entering the number.
180 - English
button of the directional control [4].
button of the directional control