Answering Machine - Silvercrest SDT 1.7 A1 Bedienungsanleitung Und Serviceinformationen

SilverCrest SDT 1.7 A1

Answering Machine

When setting the device up for the first time, the answering machine will be enabled by default with
the pre-set outgoing message. Decide whether you want the answering machine to be on or off.
You can recognise the enabled answering machine from the activated display [17] on the base.
You can conveniently configure the answering machine from the handset. For a
detailed description, see the "Ans Machine (Answering Machine)" chapter on page
162.
If new messages have been left on the answering machine, this will be indicated on the handset.
The number of new messages will flash on the base display [17].
You can listen to the messages simply by pressing the Play button [20] on the base.
If the display [17] reads "FL" the answering machine memory is full. No more messages can be
recorded, even if the answering machine is enabled. Delete any messages to be able to record
more messages.
To delete all old messages press and hold the Delete Message button [16]. After the prompt, press
the Delete Message button [16] again to erase the messages.
On the handset you can listen to new messages easily by pressing the Phonebook button [3].
If messages have already been listened to but not deleted, the base display [17]
will show the number of messages. This indication does not flash.
If the answering machine has already started answering an incoming call you can
still take it over by pressing the Phonebook button [3].
184 - English