Troubleshooting; Maintenance / Cleaning - Silvercrest SDT 1.7 A1 Bedienungsanleitung Und Serviceinformationen

SilverCrest SDT 1.7 A1

Troubleshooting

Handset does not work / blank
display
The antenna icon
No ringtone from handset or
base
No ring or dial tone for outgoing
calls
The answering machine does not
record any message.
Impossible to dial out
When using the pulse dial mode with a PBX, malfunctions may occur. This is
because the PBX misinterprets the dial pulses. Switch to tone dial mode.

Maintenance / cleaning

Repairs are required if this device has been damaged in any way, for example, if the power
adapter, charging cradle or housing is damaged, if liquid or objects have penetrated the device, if
the product has been exposed to rain or moisture or if the product does not work normally or has
been dropped. If you notice any smoke, unusual noise or strange smells, switch off the device
immediately and pull the power adapter from the wall socket. If this occurs, do not continue to use
the device and have it checked out by an expert. All servicing work must be carried out by qualified
specialist personnel. Never open the housing of the device, the power adapter or the accessories.
Opening the housing can expose you to a lethal electric shock. Only use a clean, dry cloth for
cleaning. Never use aggressive liquids.
186 - English

Batteries inserted incorrectly - insert the rechargeable
batteries with the correct polarity.

Batteries are flat - recharge the batteries.

Handset powered off - press and hold the End call
button [5] to power the handset on.

Handset out of range – take the handset closer to the
is flashing
base.

Base has no power – check the base power supply.

Re-activate the ringtone or increase the ringer volume.

Telephone cable not connected properly - make sure
that you have connected the telephone cable properly.

Check the answering machine operating mode.

The memory is full. Delete old messages.

Keypad locked – disable the key lock function.