Hilti HDE 500-A22 Original Bedienungsanleitung Seite 25

Trouble or fault
The power tool or battery
gets very hot.
The foil pack holder cannot
be swiveled into the tool.
The foil pack holder does not
engage with an audible click
No mortar is dispensed from
the mixing nozzle
8 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8.1 Transport and storage of dispensers
▶ For transporting and storing the tool, set the dispensing mode selector switch to
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
2017692
*2017692*
Printed: 03.08.2018 | Doc-Nr: PUB / 5069934 / 000 / 08
Possible cause
The tool is overloaded (application
limits exceeded).
Electrical fault
The foil pack is not pushed fully
into the holder.
Piston rods not pulled back fully
The retaining lugs are dirty
The retaining lugs are defective
Mortar in the mixing nozzle has
hardened
Action to be taken
▶ Pay attention to the power
and performance rating of the
product before using it, i.e
check its suitability for the job
on hand. See the "Technical
data" section.
▶ Consult Hilti Service if the
problem persists.
▶ Push the foil pack into the foil
pack holder as far as it will go.
▶ Press the release button and
pull the piston rods all the way
back.
▶ Clean the retaining lugs.
▶ Insert a different foil pack holder
and contact Hilti Service.
▶ Unscrew the mixing nozzle
containing the hardened mortar
and fit a new mixing nozzle.
.
English 17