Hilti HDE 500-A22 Original Bedienungsanleitung Seite 23

5.5 Inserting the cartridge
1. Press the release button.
2. Pull the piston rods back as far as they will go.
3. Fit the cartridge.
4. Screw the static mixer (mixing nozzle) onto the foil pack.
5. Swivel the cartridge into the dispenser.
5.6 Discarding initially dispensed mortar
WARNING
Risk of injury Chemicals hazard.
▶ Never point the dispenser toward yourself or other persons. Incorrect use can lead to injury.
WARNING
Risk of injury Chemicals hazard.
▶ Begin dispensing mortar only after the mixing nozzle has been screwed on. Incorrect use can lead to
injury.
Discard the initially dispensed volume of mortar every time the static mixer (mixing nozzle) is changed.
The initially dispensed mortar is not suitable for use.
1. Set the dispenser volume regulator switch to
2. Squeeze the trigger until the mixing nozzle is completely full.
3. Set the dispenser volume regulator switch to the appropriate volume of mortar
◁ 1 = 1 stroke (approx. 5 ml)
◁ 15 = 1 stroke (approx. 75 ml)
4. Discard the initially dispensed volume of mortar.
5.7 Injecting mortar
Fit a new mixing nozzle for each use. Failure to observe this point will result in too little mortar being
dispensed.
1. Press the trigger.
2. Inject the mortar.
5.8 Removing the foil pack holder and foil pack
1. Set the dispenser volume regulator switch to
2. Press the release button.
3. Pull the piston rods back as far as they will go.
4. Swivel the foil pack holder up.
5. Remove the foil pack.
6. Remove the foil pack holder from the dispenser.
5.9 Removing the cartridge
1. Set the dispenser volume regulator switch to
2. Press the release button.
3. Pull the piston rods back as far as they will go.
4. Swivel the cartridge upwards.
5. Remove the cartridge from the dispenser.
2017692
*2017692*
Printed: 03.08.2018 | Doc-Nr: PUB / 5069934 / 000 / 08
5
6
7
.
9
.
.
8
.
English 15