Accessories; Installation / Commissioning; Operation; 5�1 Switching The Unit On / Off - Renfert Waxlectric light series Original Bedienungsanleitung

3.4

Accessories

2151-1500 Kit of holders Waxlectric
2155-0101 probe, small
EN
2155-0102 probe, medium
2155-0103 probe, large
2155-0104 blade, narrow
2155-0105 blade, wide
2155-0106 blade, chamfer
2155-0101 -0102
4

Installation / Commissioning

If you have also ordered the quiver and tip holder you must mount them on the control unit:
• Quiver:
Position the quiver on the side (Fig. 1), then first move it up (Fig. 2) and then towards the front (Fig. 3)
to lock it in place�
• Tip holder:
Hook the retainer tabs of the tip holder into the openings on the back of the control unit (Fig. 4), then tilt
the holder down until it locks in place (Fig. 5).
⇒ Screw the desired modelling tip into the handpiece (Fig. 6). Make sure the tip IS NOT skewed or
cross-threaded!
⇒ Connect the handpieces to the control unit (Fig. 7). The connecting sockets are located on the under-
side of the control unit� On the 2-channel-models, make sure the handpieces are connected to the cor-
rect sockets. The handpieces are marked with coloured rings (red / yellow). The ring colours can also
be found on the control unit's operating side (Fig. 8).
The pins must audibly snap into the sockets.
⇒ Feed the handpiece connecting cables through the guide rings towards the front of the unit (Fig. 9).
⇒ Connect the mains power supply unit to the control unit� The connecting socket is located on the under-
side of the control unit (Fig. 10a). Feed the power cord out through the opening on the back of the unit
(Fig. 10b).
⇒ Using the power cord provided, connect the transformer to the mains power supply (Fig. 11).
Use only the OEM mains power supply unit!
5

Operation

5.1 Switching the Unit ON / OFF
The unit is switched on and off at switch (A, Fig. 12).
The LED (B, Fig. 12) goes on once the unit is switched on.
-0103 -0104 -0105
2155-0107 Hollenback, horizontal
2155-0108 Hollenback, vertical
2155-0109 probe, mini, angled
2155-0110 lance blade
2155-0111 blade, beaver-tail
2155-0112 large wax knife
-0106 -0107 -0108 -0109
- 6 -
-0110 -0111 -0112