Getting Started; Auto-Standby - auna Karaboom 100 Bedienungsanleitung

EN
18

GETTING STARTED

Caution: Danger of electric shock.
When you unplug the AC power cord always pull the plug from
the socket. Never pull the cord. Before connecting the AC power
cord, ensure you have completed all other connections.
Place the unit in the desired position and unravel the mains cable. Insert the
cable into the supply socket and switch on if applicable.

Auto-Standby

When playing media from a connected device, the Tower automatically
switches to standby if
• No button is pressed for 10 minutes,
• No audio from a connected device for 10 minutes.
Setting Clock
After the unit is plugged into a mains supply or mains power failure, the
display will show the "0:00" on the LED display. The unit should be in
standby mode to set the current clock.
1. Press TIME/ALARM button, the digits for the display will blink.
2. Press the  , button repeatedly until correct hour is set. Press the
TIME/ALARM to confirm the hour setting.
3. The minute digits on the display will blink.
4. Press the   button repeatedly until correct minute is set. Press the
TIME/ALARM to confirm the minute setting.
Setting Alarm
This unit can be used as an alarm clock, USB/ FM is activated to play at a
preset time.
1. Press the Standby switch to switch the unit to standby mode.
2. Make sure that you have set the clock correctly.
3. Press and hold TIME/ALARM button in shutdown state, the display will
flash ON to select setting alarm and the display will blink.
4. Press the TIME/ALARM confirm, the time display will blink.
5. Press   dbutton repeatedly to set hour. Press TIME/ALARM to
confirm.
6. Press   to set minute.
7. Press ALARM to confirm, and then press  , to select FM/USB status.
Press TIME/ALARM to confirm.