Getting Started; Bt Function; Technical Data - auna Line 100 A Bedienungsanleitung

EN
16

GETTING STARTED

1 Connect the one end of the right tower cable to the right output port on
the back panel of the left tower. Also place the cable extended tower to
the right side and the other to the left side while listening.
2 Connect one end of 3.5mm stereo audio plug to the audio output of PC
or other audio sources.
3 Make sure all the cables above are connected correctly, then connect
the power cord to AC power.
4 Switch on the power, the red led display shows (-----). Then press power
button either on the remote or left speaker front panel.
5 The SB mode in the mic represents the standby mode which works
when the mic is to be stopped for few seconds or minutes without
being switched off

BT FUNCTION

1 Activate BT on your smart device.
2 Search for the device name „Auna".
3 Connect Suie to the speakers.
4 If your device uses BT 2.0 or below, you may need to enter „0000" as
the password.

TECHNICAL DATA

Item number
Power supply
10033072
220-240 V ~ 50/60 Hz