Chal-Tec 10009322 Anschluss- Und Anwendungshinweise Seite 16

About the installation
 In order to improve the projector service life, it should not place in a wet and ventilation condition.
 Do not put the projector under the sunshine directly.
 Projector working temperature: 0°C -+3 5°C 0
Projector store temperature: -2()"C ~+70"C 0
 Do not block the ventilation-window of projector. If the projector interior temperature is too hot, the
machine will be shut off automatically. This is hot protected system. So please clean the filter of
projector per month. It is very important. Do not let the dust cover the filter.
About Open and close the projector
 When close the projector, press the power key again. And then the lamp shut off. But the fans still
work until 5 minutes later. When close the projector, do not pull out the power cable directly. After 5
minutes, the projector will shut off automatically.
Warning:
Fans will adjust the temperature. It is controlled by system when the projector work, the fans tum slowly or
quickly, so the fans noise are different. But it is normal when the projector work. Do not pull out the power
cable. If the fans stop to work, it will cause the projector interior temperature very high, so it may damage
the projector.
Projector Description
The projector is able to connect signals: HDMLY/Pb/Pr, VGA and TV (optional), as well as stereo audio input.
Please connect in reference to the following diagrams.
Front
Back
Warning
Instructions
1. Focus lens
2. IR receiver
3. High-feet adjustment
4. Cool winds input ventilation
5. Hot wind output ventilation
6. Power switch
7. Input terminals - Details below