Forehead Measurement - Beurer FT 85 Gebrauchsanweisung

You can also activate the illuminated display manually by briefly pressing the LIGHT/SET button.
The display lights up for 5 seconds.
The automatic and manual illuminated display cannot be used while measurement is in progress.
The acoustic signal symbol flashes on the display (Fig. 9).
You can activate/deactivate the acoustic signals (device activation, measurement in pro-
gress, measurement completion).
• To activate the acoustic signals, use the MODE/MEM button to select
with the LIGHT/SET button.
• To deactivate the acoustic signals, use the MODE/MEM button to select
firm with the LIGHT/SET button.

8. Forehead measurement

Beurer tip
Remember:
• Physical activity, increased perspiration on the forehead, taking vasoconstrictive medication and skin irritations can
distort the measurement.
• The forehead, or the temples, must be free from perspiration and cosmetics.
• We recommend that you take three measurements on the forehead. If the three measurements are different, use the
highest value.
• If the forehead area is covered in hair, sweat or dirt, clean the area and then wait for 10 minutes to improve the preci-
sion of the measurement.
• It is important that you keep the thermometer still during measurement. Moving the thermometer during measurement
may cause imprecise measurements.
, and confirm
, and con-
31
Fig. 9