Important Information; Packing List; General; Purpose - SciCan STATMATIC 31 Gebrauchsanweisung

1 Important Information

1 Important Information
Congratulations on your selection of the STATMATIC handpiece maintenance unit. We are confident that you have
purchased the finest equipment of its type. The STATMATIC is a compact, counter-top unit that features a number of
maintenance cycles designed to meet your needs and suitability for handpiece maintenance.
The details of installing, operating and servicing your STATMATIC unit are all contained within this manual. To
ensure years of safe, trouble-free service please read these instructions before operating this unit and keep them for
future reference. Operational, maintenance and replacement instructions should be followed for the product to
perform as designed. Contents of this manual are subject to change without notice to reflect changes and
improvements to the STATMATIC product.

Packing List

Basic unit STATMATIC
Power cord set
Instruction manual
Absorption pad
Pneumatic hose

General

The STATMATIC has been developed and manufactured according to the latest quality and safety standards.
However, some precautions should be taken for installation and operation.
•
When leaving the processing area for an extended time period (e.g. holidays), the STATMATIC should be
disconnected from the power supply.
•
The STATMATIC containing an inserted spray can should be protected from heating up over 50°C.
•
Modifications carried out by third parties will result in voiding the warranty and cancellation of the electrical
certification of this product.
•
For operation or repair it is recommended to use only SciCan original parts, as they have been qualified in
extensive tests for safety, function and specific suitability. Use of other products or components can void the
warranty of the unit.
•
Observe all warning information on the unit and in the instruction manual.
•
The unit may only be supplied with the voltage indicated in the instruction manual and on the unit.
•
Users must not attempt to service the unit exceeding those points described in the instruction manual.
Following maintenance in the STATMATIC unit, the instruments must be further treated (sterilized) according to local
guidelines and manufacturer's information/instructions.

Purpose

The STATMATIC is intended for cleaning, service and maintenance of tool holders, angle pieces and turbines used
in dentistry.
For further information about the suitability of certain instruments for servicing please refer to the manufacturer's
instructions.

Qualification of the User

The STATMATIC may be used only by trained personnel who may include dentists and their assistants.

Intended Use

The STATMATIC may only be used for the applications defined in "Purpose".
The STATMATIC should by operate in well ventilated areas to avoid possible explosive conditions.

Disposal

Consumables:
The wastes incurred are to be recycled or disposed of in a way that is harmless for human beings and the
environment; in doing so, the national valid regulations are to be observed.
Units and accessories at the end of their serviceable lives:
Europe: this product is subject to the EC Directive (WEEE 2012/19/EU), known as the European Union's WEEE
Directive (Directive on Waste Electrical and Electronic Equipment). Under this directive, waste electrical product must
be disposed of according to the local regulations concerning their recovery and safe disposal.
Additional information can be obtained from the manufacturer or your dental supplier.
This product has to be recycled or disposed of in a way that is harmless for human beings and the environment; in
doing so, the national valid regulations are to be observed.
Page 3 STATMATIC 31 EN