Cleaning And Maintenance; Disposal; Transportation; Troubleshooting - CMi 115316 Originalbetriebsanleitung

115316_Schredder_Elektrisch.book Seite 35 Mittwoch, 18. Mai 2016 4:19 16
The pressure plate is set at the factory. Adjustment
is only required when it is worn or, if need be, after
clearing blockages. Wear can be seen by the fact
that material is only squashed and remains attached
in a chain-like manner.
– Switch the directional switch (5) to the forwards
position, and switch on the product.
– Turn the adjustment screw (8) clockwise until
you can hear minor grinding noises.
– The pressure plate has been adjusted.
CAUTION! Device damage! Adjusting the
pressure plate too far will cause
unnecessary wear.
Replacing the pressure plate
DANGER! Risk of injury! Switch the
product off and pull the power plug before
replacing the pressure plate. Wait until all
moving parts have come to a standstill
and the product has cooled down.
Figure 7 – Page 5
– Undo the four screws (9) and remove the protec-
tive plate (10).
– Replace the pressure plate (11).
– Replace the protective plate (10) back on the
product and secure using screws (9).

Cleaning and maintenance

DANGER! Risk of injury! Switch off the
product and disconnect from power
before all cleaning and maintenance work.
Wait until all moving parts have come to a
standstill and the product has cooled
down.
Cleaning the product
Careful handling and regular cleaning ensure that the
product stays fully functional and efficient over a
long period of time.
• Remove loose dirt with a brush.
• Wipe the tool with a damp cloth.
• Never spray the product with water or expose to
water.
• Never use cleaning fluids or solvents for clean-
ing. This may irreversibly damage the product.
The plastic parts may be attacked by the chem-
icals.
• Keep ventilation slots clean and free of dust.

Disposal

Disposal of product
Products with this symbol may not be dis-
posed of with the household waste. You
are obliged to dispose of these products
separately.
Contact your community authorities for
information regarding the correct disposal of the
product.
By disposing of the product correctly you are ensur-
ing that it will be recycled or processed for reuse.
This helps to prevent hazardous material from dam-
aging the environment.
Disposing of the packaging
The packaging is made of cardboard and separately
labelled foil which is also recyclable.
– Take these materials to a recycling centre.

Transportation

• Secure the product to prevent shifting.
• When dispatching, try to use the original pack-
aging, if possible.

Troubleshooting

DANGER! Risk of injury! Unprofessional
repairs may mean that your product will
no longer operate safely. This endangers
you and your environment.
In many cases, small defects can lead to a malfunc-
tion. You will usually be able to deal with these your-
self. Please consult the following table before con-
tacting the service department. This may save you a
lot of effort and quite often money.
GB
35