Installation - EuroLite 50101150 Bedienungsanleitung

1 Only mount the mirror ball to the motor type MD-3010 (for 75 & 100 cm mirror balls item no. 50101150,
50120070, 5010150A, 50120075) or to the motor type MD-3050 (for 150 cm mirror ball item no. 5010160A) or
a motor which meets the relevant technical requirements.
2 Use mounting hardware that is compatible with the structure and capable of bearing the weight of the mirror
ball. Please refer to the "Accessories" section for a list of suitable hardware. Never use abrading material such
as steel cables in order to avoid material wearing.
3 Install the main attachment chain (max. 100 cm) with the screw-on chain link at the installation eyelet of the
mirror ball and tighten the fixation screw. Then insert the fourth chain link of the secondary chain with the mirror
ball in the screw-on chain link and tighten the fixation screw too.
4 Provide fall protection with an additional chain. The safety chain must be slightly longer than the main
attachment chain. Pull the safety chain through the attachment eyelet of the mirror ball and in the attachment
eyelet of the motor.
5 Please check in regular intervals if the mounting hardware (e. g. shackles, screw-on carabiners or screw-on
chain links) or chain links have been deformed. Uninstall the mirror ball immediately in such a case.

INSTALLATION

(1) Mirror ball motor
(2) Motor axle
(3) Screw-on chain link
(4) Mirror ball chain
(5) Installation eyelet
(6) Mirror ball
(7) Attachment eyelet
(8) Safety chain
(9) Attachment eyelet
10 • EN