Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The wood fibres are thus pressed against the stress corrosion
protection (13) or (15) during sawing, which prevents the ed-
ges being torn.
The area of application is limited to right-angled (90°)
cuts.
Maintenance
All tools are contaminated by dust when working with wood.
Proper care is therefore essential. Always keep the ope-
nings required for the cooling of the motor free of dust and
dirt. The movable supporting roller for the saw blade should
be given a drop of oil from time to time. Other than this, the
jigsaw is virtually maintenance-free. Before leav-ing the fac-
tory all moving parts are well lubricated.
Replacing carbon brushes
Our service depots will do this and all other servicing work
quickly and professionally.
Mains cable
Damaged mains cables must not be used. They are to be
replaced immediately.
This has been made very straightforward by the new mains
cable module (11). Press both locking keys (12) and pull the
mains cable module (11) out of the handle. Insert the new
mains cable into the handle and lock in place. Different
lengthed mains cables are available as special accessories.
Only use the mains cable module for KRESS power
tools! Do not attempt to operate other electrical applian-
ces with it!
Noise/vibration information
Measured values correspond with EN 50144.
Sound pressure level:
Sound power level:
Work place emission value: = 82
Operators require noise protection equipment.
The weighted acceleration is typically 4.5 m/s
Environmental protection
Kress takes back worn-out machines for the purpose of re-
source-saving recycling. As a result of their modular con-
struction, Kress machines can be very easily dismantled
into their reusable materials.
Give your worn-out Kress machine to your dealer or send it
directly to Kress.
Subject to change without notice.
+3
= 79
dB (A)
+3
= 92
dB (A)
+3
dB (A)
2
.
Werbung
