Setting Up And Connecting; Commissioning - ATE BFCS 300 Anleitung

Setting up and connecting

Setting up (figures on page X)
• Set up the device horizontally
• Do not place it on radiators
• Do not place it in sunlight
• Protect it from moisture and vibrations

Commissioning

Switching on (figures on page XI)
Switch on the power switch on the side
of the device
= After switch-on, "TEST" appears on
the display for 5 seconds.
Then "I.O." is displayed for a second.
Finally, "0" is displayed and the "Start"
indicator lamp lights up. The device is
now ready for measurements.
If an error occurs in the process,
"ERR6" will be displayed (see
Troubleshooting page 27).
Clean the sensor head before the
first measurement. To do this, carry
out two to three measurements
with new brake fluid.
Hold down the "Memory" button
when setting the time and date. The
counter goes up automatically until
the button is released.
Connecting (figures on page XI)
• Connect the device to an easily
accessible socket so that the power
plug can be pulled quickly in the event
of a hazardous situation
• To connect to the mains, use the 3-pin
ATE power cable supplied or another
cable manufactured according to
industry standards with a protective
conductor and plug
• Never operate the device without
proper earthing
Switching to setting mode
(figures on page XII)
1. Switch the device off
2. Wait until all of the indicator lamps
have gone off (approx. 2 seconds)
3. Press the "Start" button while
switching on the device and release
the button after 4 seconds
= "P1" appears on the display.
Manual – BFCS 300
21
English