auna multimedia Auna TT1200 Handbuch Seite 18

LISTENING TO RADIO & RECORDING TO USB/SD
NOTE:
IT IS RECOMMENDED THAT A 4GB MEMORY STICK IS USED WHEN RECORDING TO USB
RADIO TUNING
1. PRESS FUNCTION BUTTON TO SELECT "TUNE" MODE.
2. SELECT THE DESIRED BAND BY RADIO BAND BUTTON (AM OR FM).
3. TUNE TO THE REQUIRED STATION BY PRESSING SKIP UP OR SKIP DOWN BUTTON FOR 1-2 SECONDS,
AND THEN RELEASE.
4. RADIO FREQUENCY CAN ALSO BE ADJUSTED MANUALLY BY PRESSING AND RELEASING SKIP UP
OR SKIP DOWN BUTTON IMMEDIATELY.
5. THE UNIT WILL START SEEKING AUTOMATICALLY AND STOP WHEN A RADIO STATION IS FOUND.
MANUAL PRESET RADIO STATIONS
1. WHEN THE DESIRED RADIO STATION IS FOUND, PRESS MODE BUTTON, PROGRAM NUMBER
WILL BE FLASHING.
2. PRESS PRESET UP OR PRESET DOWN TO CHOOSE THE PROGRAM NUMBER FOR STORING THE
DESIRED RADIO STATION.
3. PRESS MODE BUTTON AGAIN TO CONFIRM, PROGRAM NUMBER WILL STOP TO FLASH.
4. REPEAT STEP 2 & 3 UNTIL ALL DESIRED RADIO STATIONS IS BEING FOUND AND STORED
5. PRESS PRESET UP OR PRESET DOWN TO CHOOSE THE PRESE RADIO STATIONS.
6. THE NUMBER OF STATIONS CAN BE FOUND AND STORED IS DEPENDED ON THE RECEPTION OF
DIFFERENT AREA AND COUNTRIES.
AUTO PRESET RADIO STATIONS
1. DURING RADIO MODE, PRESS THE PLAY/PAUSE BUTTON, THE UNIT WILL AUTOMATICLLY SCAN
THE RADIO FREQUENCY. WHEN THE CLEAR SIGNAL IS FOUND, IT WILL AUTOMATICALLY STORE
THE RADIO STATION, STARTING FROM PROGRAM NUMBER 1.
2. THE NUMBER OF STATIONS CAN BE FOUND AND STORED IS DEPENDED ON THE RECEPTION OF
DIFFERENT AREA AND COUNTRIES.
FM & FM-STEREO RADIO RECORDING TO USB/SD
1. PRESS FUNCTION BUTTON TO SELECT "TUNE" MODE AND SELECT THE DESIRED BAND BY BAND
BUTTON (AM OR FM).
2. INSERT MEMORY DEVICE (USB DRIVE, SD OR MMC CARD)
3. PRESS THE REC BUTTON; IT WILL TAKE 3-5 SECONDS TO READ MEMORY DEVICE. THEN USB OR SD
ICON WILL BE FLASHING.
4. PRESS SKIP DOWN
FOR ENCODING. THEN PRESS REC BUTTON AGAIN TO CONFIRM. AND THE SYSTEM IS STARTING
THE ENCODING MODE AFTER FEW SECONDS.
5. IF ONLY USB DRIVE, SD OR MMC CARD IS INSERTED, STEP 4 CAN BE SKIPPED.
6. THE USB OR SD ICON WILL BE FLASHING ON THE DISPLAY DURING ENCODING.
7. TO FINISH RECORDING, PRESS REC BUTTON AGAIN AND DISPLAY WILL SHOW "END" AND RETURN
TO TUNER MODE.
BUTTON OR SKIP UP BUTTON TO SELECT DESIRED MODE (USB OR SD)
18