Daily Servicing Of Splitting Saw; Overhaul Service (To Be Carried Out Every 50 Operating Hours); Repairs By Schmid & Wezel Customer Service Technicians; Transport And Storage - EFA SB 287 E Betriebsanleitung, Wartungsanleitung, Ersatzteilliste

6.2 Daily servicing of band saw
In order to meet the hygiene requirements, the
band saw must be serviced after each shift.
6.2.1 Lubrication
After cleaning, apply a little EFA special oil (acid-free
product) to the saw band and lubricate the guide
mechanism with EFA grease.
6.2.2 Guide
The guide mechanism must be serviced with special
care. If there are any signs of wear, immediately
adjust it or replace it, if necessary.
Check the guide mechanism and the spring for free
movement and lubricate it.
6.2.3 Saw band
Regularly check the saw band; if worn, replace it.
6.2.4 Motor
Regularly unblock the condensate drain holes at the
bottom of the motor, using a blunt non-metal tool.
If condensate collects inside the machine, the motor
might fail (corrosion of winding), causing high repair
costs.
6.3 Overhaul service
(to be carried out every 50
operating hours)
6.3.1 Band saw
Check ball bearings of the guide wheels and
lubricate, if necessary.
6.3.2 Guide
Apply a little lubricant to the two guides.
6.3.3 Torque wrench
Over the weekend, place the torque wrench in an oil
bath. Do not lubricate.
6.3.4 Gear system
The gear is equipped with permanent lubrication.
The lubrication must however be renewed after
repairs.
6.4 Repairs by Schmid & Wezel
customer service technicians
Before carrying out any repair
work, disconnect the band saw
from the power supply!
All repairs must be completed by authorised
Schmid & Wezel
D 75433 Maulbronn
specialist technicians.
Schmid & Wezel operates an extensive after-
sales service network. Contact your local
authorised repair shop or the Schmid & Wezel
customer service department for more
information on our services.
Please note that electric machines must be
repaired by qualified electricians as improper
repairs might lead to serious injury to the
operator.
On request, we provide spare parts lists for
repair shops with specialist technicians.
After completion of the repair work, the gear
system must be lubricated again for life!

7. Transport and storage

The band saw must be stored in a dry, well-
ventilated room.
For transport, clean the machine as described in
chapter 6.1.2 "Cleaning of band saw" (page 11),
and dry it thoroughly.
During transport, protect the cutter against damage
from impacts, etc.
8. Return of decommissioned
equipment
For proper disposal, return your equipment to
Schmid & Wezel.
Page / Seite
24 / 39
Version/ Ausführung
09.2012