Operational Safety; Working With The Splitting Saw; Installation And Assembly; Changing Saw Band - EFA SB 287 E Betriebsanleitung, Wartungsanleitung, Ersatzteilliste

3.3 Working with the band saw
Never reach into the operating
range of the saw band. as limbs
could be severed!
All installation work must be
carried out by suitably trained and
authorised technicians.
Always wear goggles or other
effective eye protection!
3.3.1 Cutting process
Prior to starting the stunning device, compare the
technical data of the power supply mains with that
of the tool.
Hold band saw with both hands at the handles
and switch it on.
Insert into meat while the saw band is running.
Remove the saw from the cut while the band is
still running and release the switching lever to
switch off the saw.
See also chapter 3.2 "Operation of switch" (page 4).

3.3.2 Operational safety

For safety reasons, the EFA SB 287 E is equipped
with 2 operating handles.
Hold the machine by the two switching handles.
Never attempt to operate it with one hand.
While the device is switched on, proceed with
extreme caution.
Never remove any safety devices to disassemble
the band saw.
For safe operation with proper guidance, the
band saw should be attached to a spring-loaded
pulley system.
When switched on, do not reach into the
operating range of the saw band.
Do not actuate the motor switch while inserting
the saw band.
Regularly check the suspension mechanism for
damage.
Adhere to the general safety instructions in
chapter 2 "Safety instructions" (page 2).
Schmid & Wezel
D 75433 Maulbronn

4. Installation and assembly

Before carrying out any installation
work, disconnect the stunning
device from the power supply!
All assembly work must be carried
out by suitably trained and
authorised technicians.

4.1 Changing saw band

The saw band may only be changed
after the machine has been
disconnected from the power
supply!
Never reach into the operating
range of the saw band. as limbs
could be severed!
The band saw is equipped with a switch-on
protection mechanism, so that it cannot be started
if one of the two covers is opened.
4.1.1 Dismantling saw band
Open the two covers (B) by pulling the tab (C) (the
covers are equipped with magnet snap
mechanisms). Release the saw band by turning the
torque wrench (D) anticlockwise. The saw band is
now released.
Lift the guide mechanism with the lever (E) and slide
the band from the guides and across the wheels
(see chapter 4.2 "Saw band guide mechanism"
(page 6).
SB 287 E = Torque wrench (included as separate
tool with machine - product number 001 963 363)
Page / Seite
17 / 39
Version/ Ausführung
09.2012