Cleaning And Maintenance; Daily Cleaning At Shift End - EFA SB 287 E Betriebsanleitung, Wartungsanleitung, Ersatzteilliste

6. Cleaning and maintenance

Before carrying out any cleaning or
maintenance work, disconnect the
cutter from the power supply!
Before carrying out any
maintenance work, open the
covers (B) (switch-on protection)
to prevent inadvertent restart!

6.1 Daily cleaning at shift end

For disruption-free operation, ensure that the band
saw is always kept clean. Disinfect tool before
cleaning it.
Always comply with the relevant safety and hygiene
requirements (DIN EN 1672)!
Ensure that disinfectants are not brought into
contact with food, whether directly or indirectly.
Rinse tool thoroughly with water to remove all
disinfectant.
Do not use aggressive detergents!
Do not clean with steam or high-
pressure water jet! Do not
immerse cutter in water!
6.1.1 Disinfection
During operation, the band saw will be disinfected
after each cut with hot water (82° C).
6.1.2 Cleaning of band saw
After each shift, release the saw band (see chapter
4.1.1 "Dismantling saw band" (page 5)), remove it
from the machine, clean it with water and dry it.
After each shift, remove the guide mechanism and
clean the boreholes (see chapter 4.2 "Saw band
guide mechanism" (page 6)).
Clean the band saw with a brush and cloth, using
warm water (40 - 55° C). To remove persistent or
encrusted dirt, soak the saw in warm water. Apply
detergent, possibly in the form of foam, on the
affected area and let soak for 15 to 20 minutes.
Wash with warm water.
Recommended cleaning agents
Diversey Lever Tego 2000:
surface-active disinfectant
Diversey Lever GmbH
Mallaufstr. 50-56, 68219 Mannheim, Germany
Schmid & Wezel
D 75433 Maulbronn
Alternative product:
P3-topax 91:
surface-active disinfectant
Henkel-Ecolab Deutschland GmbH, Postfach 13
04 06, D-40554 Düsseldorf, Germany
For a cleaning schedule and detailed instructions,
contact the above suppliers.
The detergents listed above are recommended
products. If you wish to use other products, you are
obliged to test them as regards suitability and
compliance with the applicable hygiene regulations.
6.1.3 Lubricants
The lubricant and the hydraulic fluid must meet the
requirements of the relevant regulations (DIN 1672)
as regards suitability for use in food processing.
Recommended gear lubricant
Klübersynth UH1 12-1600 (H1)
EFA special grease
Order no. 001 365 644 (0.8 kg)
Order no. 001 365 645 (5.0 kg)
Quantity of lubricant for gear:
EFA SB 287 E: 600 g
Recommended lubricant for all lubrication
points, guides and torque wrench
Molykote Lomgterm W2
EFA special grease
Order no. 001 365 623 (1 kg)
Order no. 001 365 624 (5 kg)
Recommended oil for torque wrench oil bath
Shell-Ondina G17, 15 Centistok / 40°
Special oil
Order no. 001 365 611 (0.5 l)
Order no. 001 365 612 (5.0 l)
Page / Seite
23 / 39
Version/ Ausführung
09.2012