Adjusting Spring-Loaded Pulley; Maintenance - EFA SB 287 E Betriebsanleitung, Wartungsanleitung, Ersatzteilliste

4. Dismantle the guide and lever.
Figure 12: Dismantling guide and lever
4.3 Adjusting the spring-loaded
pulley
The spring-loaded pulley can be adjusted by turning
the PLUS/MINUS screw at the housing (see Abb.
13).
Figure 13: Spring-loaded pulley
Turn the screw in MINUS direction until the tool
is balanced and suspended at the correct
height.
If it is not possible to pull more cable from the
pulley, it is jammed and must be readjusted.
Turn the screw in PLUS direction until cable can
be pulled from the pulley and repeat the fine
adjustment (see above).

5. Maintenance

Malfunctions that might occur during operation can
generally be eliminated very simply. Table 1:
"Troubleshooting" lists possible faults, their causes
and remedies.
Schmid & Wezel
D 75433 Maulbronn
Page / Seite
20 / 39
Version/ Ausführung
09.2012