Werbung
Apply magnetic pen, see page 3
Functions can be activated and settings are made with
the magnetic pen.
The electronic signals activities by beeps.
Caution Risk of injury
Danger of crushing due to strong attraction of the
magnet.
Risk of eye injuries and cuts from splinters of the
magnet.
Magnet gently introduce them to other magnets or
magnetic hardware.
Caution with allergy!
Magnet contains nickel und NdFeB.
Caution with pacemakers
People with pacemakers must keep sufficient
distance to magnets (min. 300mm)
Caution caused by magnetic field
Keep magnet away from electrical devices and
objects, which can be damaged by magnetic fields.
The safety data sheets for the product can be downloaded
from www.grohe.com/nachhaltigkeit.
Activating cleaning mode,
see page 1.
Signalling the remaining battery capacity,
see page 1.
Fault / Cause / Remedy
Fault
Cause
Water not flowing
• Water supply interrupted
• Filter in solenoid valve blocked
• Solenoid valve defective
• Plug-in connector without contact
• Battery discharged
(Electronics signaled beeps)
• Outlet clogged
• Temperature sensor defective
• Through high ambient temperature, the
water temperature in the siphon and in the
water supply is > 35 °C
• Flushing during continuous use is activated
(Flushing is initiated every 8 min.
independent of the use)
Undesired water
• Automatic flushing activated
flow
• Through high ambient temperature, the
water temperature in the siphon is > 35 ° C
• Solenoid valve defective
Flow volume too
• Solenoid valve defective
low
• Filter in solenoid valve blocked
7
Making settings
Activating setting mode
Disconnect the power supply to the electronics and reconnect
after 10 s.
Setting mode is automatically terminated after 3 minutes.
Setting the flow volume, see page 2.
Setting the programme, see page 3.
Maintenance
, see page 4
Batterie, see Fig. [2]
Solenoid valve, see Fig. [3]
Siphon with temperature sensor, see Fig. [4]
Elektronic, see Fig. [5]
Replacement parts
see fold-out page I
Disposal note
This category of device does not belong in the
domestic waste, but must be disposed of separately
in accordance with the relevant national regulations.
Remedy
- Open shut-off valves
- Clean filter
- Replace solenoid valve
- Check plug-in connector
- Replace battery
- Clean outlet
- Replace siphon with temperature sensor
- Ensure operating temperature of the water in the
water supply
- After drop of the temperature in the siphon the
elektronic terminates the mode flushing during
continuous use automatically
- The elektronic triggers a flushing to reduce the
water temperature in the siphon
- Replace solenoid valve
- Replace solenoid valve
- Clean filter
Werbung
