Listening To The Radio - AEG EC4836 Bedienungsanleitung

Listening to the Radio

Hints for FM Reception
• The FM reception depends on the location.
Follow the steps below:
- Fully unwind the wire antenna.
- If necessary, change the position of the wire antenna to
improve the reception.
• Depending on the location, some station may not be
received in your region or only with interference. This is
not a malfunction of the device!
Scan FM Stations
1. Repeatedly press FUNCTION / button until the display
shows "FM".
2. You have two possibilities to look for and store radio
stations.
Automatic Station Scan
Important! Any previously stored radio stations will be
overwritten.
Press and hold the / / SCAN button for approx.
3 seconds. The device is searching the complete FM
frequency band for radio stations. The stations found are
stored ascending by frequency.
Searching for Radio Stations Manually
Tune the desired stations with the
/ TUNE – buttons. When holding down either of the
buttons, the device will start scanning until the next radio
station is found. The display will show the respective
frequency.
Storing Stations:
1. Search for a station as described in "Searching for
radio Stations Manually".
2. In order to store the radio station, press the
P-MODE / MEM. button. The next pre-set location (for
example P – 02) flashes in the display.
3. Use the FOLD. / 10 / MEM. buttons to select the
desired memory location.
4. Press the P-MODE / MEM. button. The radio station
will be stored.
Selecting Stored Radio Stations
The stored radio stations can be selected by repeatedly
pressing the FOLD. / 10 / MEM. buttons.
Microphone Operation
You may switch on the microphone for the Karaoke function
during any playback mode.
EC4836_IM
Using the Microphone
NOTE:
• In order to prevent an accoustic "build-up", turn both
controls (MIC VOL and ECHO MIC) anticlockwise to
the left as far as they will go. Only then plug the micro-
phone cable into the jack.
• Due to the high power amplifier of the device, any
noise will also be strengthened through the micro-
phone. This is not a malfunction of the device!
1. Connect the microphone with the port MIC 1 or MIC 2.
2. Slide the switch on the microphone upward in the direc-
tion "ON".
3. Adjust the microphone volume with the MIC VOL control.
4. Use the ECHO MIC control to generate echo effects.
5. Turn off the microphone when you do not use it. Slide the
switch downward in the direction "OFF".
CAUTION:
To avoid audio feedback (sharp whistling sound), use
the microphone outside of the speaker' s reverberation
distance.
Guitar Operation
You have the option to connect an e-guitar to the loudspeak-
er.
/ TUNE + and
1. Connect your e-guitar to the GUITAR jack.
2. Control the guitar volume with the GUITAR VOL control.
Playing Back Music Files
You can play back your own music files in three ways: Via
cable, cordless via Bluetooth, or via the USB port.
By Cable (Cable not included)
1. If required, use a suitable adapter (not included).
Connect the external device as follows:
• Connect to the PC / AUX IN socket using a 3.5 mm
2. Use the FUNCTION / button to select AUX mode.
3. Start the playback of your audio source. Listen to the
sound playback via the speaker.
4. For the further procedure, please refer to the user manual
of the external audio source.
NOTE:
If possible, adjust the volume of the external unit to a
comfortable level.
Playing Back Music via Bluetooth
Bluetooth involves a technology for wireless radio connection
of devices over a short distance. Devices with Bluetooth
standard are transmitting between 2.402 and 2.480 GHz in
the ISM band (Industrial, Scientific and Medical). Interference
stereo jack plug cable.
English
37
03.08.16