Hantech 4619275 Bedienungsanleitungen Seite 26

In dehumidification mode, the
ambient temperature is low.
There is direct sunlight.
Doors or windows are open; there
are a lot of people; or in cooling
The cooling
mode, there are other sources of
effect is not
heat.
good
The filter screen is dirty.
The air inlet or outlet is blocked.
The air conditioning is not placed
Big Noise
on a flat surface.
compressor
Overheat protection starts.
does not work.
The
machine and the remote control is
too far.
The remote
control does The remote control is not aligned
not work. with the direction of the remote
control receiver.
Batteries are dead.
Displays 'E1'.
The pipe temperature sensor is
abnormal.
Displays 'E2'
The room temperature sensor is
abnormal.
Note: If problems not listed in the table occur or recommended solutions do not work,
please contact the professional service organization.
distance between
EN
The machine is placed in a room with an
ambient temperature of greater than
17 ℃ (62 ℉).
Pull the Curtain.
Close doors and windows, and add new
air conditioning.
Clean or replace the filter screen.
Clear obstructions.
Put the air conditioning on a flat and hard
place (to reduce noise).
Wait for 3 minutes until the temperature
is lowered, and then restart the machine.
the
Let the remote control get close to the air
conditioning, and make sure that the
remote control directly faces to the
direction of the remote control receiver.
Replace batteries.
Check the pipe temperature sensor and
related circuitry.
Check the room temperature sensor and
related circuitry.
24