Collomix CMG 2600 Originalbetriebsanleitung Seite 13

work, in case of a voltage drop, or when inserting/
mounting an accessory part.
► Switch off the machine if it comes to a standstill
for any reason. This will prevent any sudden run-
up while the machine is unattended.
► Do not use the machine if any part of the housing
is defective, or if any damage is detected on the
switch, power line or plug.
► Ensure that the rotational speed stated on the
grinding disk is equal to or higher than the mo-
tor speed of the machine. Only use appropriate
accessory parts.
► The exterior diameter of the grinding cup must
match the measurements provided on the power
tool.
► Diamond cup wheels and flanges must fit exactly
onto the grinding spindle of your power tool.
► Diamond cup disks must only be used for their
specified applications.
► The device may only be operated with the protec-
tive hood undamaged and fully functional.
► Only use cup wheels which are smaller than the
lamellar ring of the protective hood.
► Replace the lamellar ring when it is worn.
Read the operating manual of the ma-
chine before use and comply with the
instructions contained therein!
Wear protective goggles and hearing
protection while working with the ma-
chine.
The use of a face mask is recommended
for dust-intensive tasks.
Wear protective gloves while working.
Assembly

Disconnect the mains plug from the wall plug
before carrying out any tasks on the device.
Adjusting the handle
Open the two wing nuts left and right and move the
handle to the desired position. Tighten the wing nuts
again.
Mounting the diamond grinding disk:
Select a diamond grinding disk that matches the grade
and specification of the material to be processed.
Only use diamond grinding disks that comply with the
data listed in the table below.
Ensure the correct size, height and diameter of the
hole in the diamond cup wheel.
The permissible rotational speed of the diamond
grinding disk used must at least match with the data
listed in the following table.
Please note the data provided on the diamond grind-
ing disk regarding its rotational and circumferential
speed.
max D [mm]
[mm]
180 22.2
► Unscrew the coupling nut (8) from the threaded
spindle using the socket spanner provided. While
doing this, press the locking button (2) and turn
the spindle by hand until you can feel it engage.
► A flange nut (6) is attached to the threaded spin-
dle to stabilise the cup wheel. When working with
the suitable Collomix diamond cup wheel, always
ensure that the flange nut is in place. Do not oper-
ate the device without the flange nut.
► Centre the diamond cup disk (11) on the flange
nut and spacer disk.
► Use a pinhole spanner to tighten the clamp nut
(10) on the threaded spindle. Press and hold the
arrester button (3) while doing so to prevent the
spindle from turning.
► Check the cup disk for correct seating and free
running before switching on the machine. The
disk must not come into contact with the protec-
tive hood or other parts.
The cup wheel can heat up during use. Leave to cool.
You could burn your hands or cut/ tear your skin on
the segments. Always wear protective work gloves
when changing tool inserts.
Carry out a test run in a safe position and without any
material load. Interrupt your work immediately if you
notice the tool running irregularly.
Only use original accessory parts!
Rev. 3 / 13
Max. rotational
d speed [min ]
-1
8500
max. height
[m/s] [mm]
80 30