Machine-Specific Safety Instructions - Collomix Xo 33 R duo Originalbetriebsanleitung

Machine-specific safety instructions


WARNING: Read all notes and instructions on
safety. Failure to observe any of the notes and instruc-
tions on safety may result in an electric shock, fire and/
or serious injury.
Make sure that you keep all notes and instructions on
safety for future reference.
To be able to use the machine safely it is essential that
you read the operating instructions and the safety
instructions thoroughly and comply with all of them.
The machine is to be used only by persons who have
read the operating instructions and who are acquainted
with the occupational safety and accident prevention
regulations in force in your country.

In addition, you must also comply with the gen-
eral safety instructions also included with the machine.
►Take care to ensure that the mains power supply cor-
responds to the specifications on the rating plate.
►Do not use the device in any environments with po-
tentially explosive atmospheres. Do not mix any read-
ily flammable solvents or solvent-containing substanc-
es with a flash point of below 21° C.
►Take care to ensure that no liquid splashes against the
motor housing and keep it away from the rain – risk of
electric shock!
►Never clean the machine with water – risk of electric
shock!
►Do not wind cables or leads around any parts of your
body.
►Do not use the machine with a damaged cable. Do not
touch the cable and pull out the power plug immedi-
ately. There is an increased risk of electric shock from
damaged cables. If the mains power cable has to be
replaced (because of damage or similar), ensure that
it is replaced by the manufacturer or an authorized
representative of the manufacturer (electrician) in or-
der to avoid any risk to safety.
►Always hold the machine firmly with both hands when
carrying out your work and make sure you have a se-
cure footing.
►Hold the machine by the insulated grip surfaces when
carrying out work where it may be possible for the
plug-in tool to come into contact with concealed pow-
er cables or the machine's own mains power cable.
Contact with a live cable may make metal components
of the machine live as well and could cause an electric
shock.
►Before starting up, check that the mixing rod is secure-
ly attached and rotates without a hitch.
►Start up and run down the machine in the mixing con-
tainer only. Ensure that the mixing container is stood
in a firm and secure position.
►Only operate the machine and the mixing tool in
perfect condition. Do not use damaged, bent or worn
paddles.
►Do not reach into the mixing container with your
hands or insert any other objects into it while mixing is
in progress. Risk of crushing!
►Wait until the machine or tool comes to a complete
standstill. Rotating tools can snag and cause injuries or
damage.
►If the sound pressure level should exceed 85 dB (A)
where you are working, use ear protection!
►We recommend that you wear work gloves and protec-
tive goggles when using the mixer. Regulations require
that you wear close-fitting clothing.
►To protect yourself from harmful dust while mixing,
wear a dust mask. Some mineral materials are deemed
to be carcinogenic. Use a dust extractor wherever pos-
sible.
►Always connect machines via a residual current device
(RCD) with a rated residual current of 30 mA or less.
Read and observe the operating instruc-
tions for the machine before you start it
up!
Always wear protective goggles and ear
protection while working.
It is advisable to wear a dust mask whe-
never working with materials which ge-
nerate large amounts of dust.
Always wear protective gloves while
working.
Wear safety shoes with steel caps during
operation
EN