Operation - Collomix Xo 33 R duo Originalbetriebsanleitung

EN Proper use
The machine is designed for mixing liquid, granular and
powder-based building products such as paints, mortar,
concrete, adhesives, plaster, mixes containing silica sand,
thermosetting resin and similar substances. Use the right
mixing tool for the consistency of the material and the
quantity to be mixed.
Please refer to the information in the technical data
when choosing the size of mixing tool (diameter/mixing
action). If the wrong mixing action or mixing tool diam-
eter is selected, this may cause the machine/gear unit
to become overloaded and lead to damage as a result.
Please remember that a mixing tool with a mixing action
from the top down puts a greater strain on the electrical
tool than one with the reverse mixing action.
This electrical tool is not designed for use in continuous

operation.

Given the high torque levels generated by the machine, it
must not be used as a power drill.
The machine must not be used for the preparation of
foodstuffs.
The machine is not suitable for mixing materials contain-
ing graphite dust, brine or slurry. Mixing of these ma-
terials or substances may damage the machine beyond
repair.
Assembly
►Always pull the power plug out of the socket outlet
before carrying out any work on the machine.
Fitting the stirrer / tool change-over (Fig. A):
Insert the mixing tool with the HEXAFIX mount in the
coupling until it locks. Make sure that the markings on
the mixing attachments match those of the respective
mixing shaft when you fit them (I + II). For trouble-free
operation the markings must match up. In addition, the
stirrers can only be fitted in certain positions. This is to
ensure that they do not come into contact with each
other.
To release or change the mixing tools, simply pull back
the handle-collar on the coupling and this releases the
mixing tool.
Switching the mixing tools over allows the mixing action
to be reversed (see page 2). This can be an advantage
for liquid materials. Please note, however: This places
greater strain on the drive unit. The protective caps are
designed to prevent the HEXAFIX coupling getting dirty
and help contribute to trouble-free operation.
Operation
►Check that the power supply shown on the rating
plate is the same as the mains power supply.
Always hold the machine firm with both hands.
1.
2.
Always work with the ON/OFF switch fully pressed.
To stop working, release the ON/OFF switch.
Tips for safe working:
Always reduce the speed when submerging the mixing
tool in the mixing material or lifting it out. Once the mix-
ing tool is fully submerged, increase the speed again to
ensure that the motor is adequately cooled.
During mixing you should guide the machine around the
mixing container. Continue mixing until all of the mixing
material is completely mixed. Please follow the process-
ing instructions of the manufacturer of the material.
The greater the viscosity of the material, the greater
the impact of the torque forces on the machine, so you
should be prepared for this when you carry out your
work.
If the mixing tool comes into contact with a surface (e.g.
the bottom of the tub) while running, it may kick back.
Set the machine down resting on the guard handle after
you have finished your mixing work.
Press the starting lockout but-
ton (1).
Press the ON/OFF switch (2).
The more pressure you apply to
the ON/OFF switch,
the faster the machine will run.
The ON/OFF switch cannot be
locked!