Getting Started With Your Water Flosser; Powering The Unit - Waterpik WP-860 Bedienungsanleitung

6

GETTING STARTED WITH YOUR WATER FLOSSER

Replace Every 3 Months
Orthodontic Tip
Pik Pocket™ Tip
Plaque Seeker Tip
®
Triple Sonic
Brush Head

Powering the Unit

Plug the cord into an electrical outlet. If the outlet is
controlled by a wall switch, be sure it is turned on.
Preparing the Reservoir
Lift the reservoir lid, remove the reservoir, and fill
with lukewarm water. Replace the reservoir over
the base and press down firmly and close the lid.
Remove
BEST FOR
Braces
General Use
BEST FOR
Periodontal Pockets
Furcations
BEST FOR
Implants Retainers
Crowns General Use
Bridges
BEST FOR
Plaque Removal
Fill
Replace Every 6 Months
Classic Jet Tip
Tongue Cleaner
NOTE: All tips not included in all models.
Replacement/attachments may be purchased
from your local distributor, which can be found at
www.waterpik.com/intl
Inserting and Removing Tips
Insert tip into the center of
the Water Flosser handle,
pressing down firmly until
the tip clicks into place.
The colored ring will be
flush with the top of
the handle if the tip
is correctly locked
into place. To remove
tip from the handle
push the tip eject
button on the handle.
BEST FOR
General Use
BEST FOR
Fresher Breath
NO
gap
Tip
release
button