Cleaning And Troubleshooting Your Waterpik; Water Flosser - Waterpik WP-650 Bedienungsanleitung

CLEANING AND TROUBLESHOOTING YOUR WATERPIK

Toothbrush Tip
Place the
toothbrush tip
in mouth with
the brush head
on the tooth at the gumline. The toothbrush tip can
be used with or without toothpaste. Using a light
pressure (bristles should not bend) massage
the brush back and forth with very short strokes –
much like you would with a manual toothbrush.
Plaque Seeker Tip
®
To use the
Plaque Seeker
®
tip, place the tip
close to the teeth
so that the bristles are gently touching the teeth.
Gently glide tip along gumline, pausing briefly
between teeth to gently brush and allow the water
to flow between the teeth.
Using Mouthwash and
Other Solutions
Your Waterpik Water Flosser can be used to
®
deliver mouthwash and antibacterial solutions.
After using any special solution, rinse unit to
prevent clogging by partially filling reservoir with
warm water and running unit with tip pointed into
sink until unit is empty.
Cleaning
Before cleaning, unplug from the electrical outlet.
Clean the product when necessary by using a soft
cloth and mild non-abrasive cleanser.
The water reservoir is removable for easy cleaning
and is top rack dishwasher safe.
Removing Hard Water Deposits
Add 2 tablespoons of white vinegar to a full
reservoir of warm water. Set pressure control dial
to high and point the handle and tip into sink. Turn
power and water switch ON and run until reservoir
is empty. Rinse by repeating with a full reservoir of
clean warm water.
Leakage
If leaking due to a damaged hose, replacement
hoses and handles can be purchased from your
local distributor, which can be found at
waterpik.com/intl.
Accessory Storage
Accessory tip storage for your two most frequently
used tips is under the reservoir lid and can be
easily accessed by removing the reservoir.

WATER FLOSSER

®
9