Radson Analog Basic RF Bedienungsanleitung Seite 10

o If it's good, adjust your setting temperature as
you want.
o If it's not good, check the installation (Antenna
position, distance...)
* To make the installation easier it will be better to have
the thermostat near to the receiver in learning mode.
6 How to caliber and limit the setting
range.
If your thermostat needs to calibrated, make these
operations:
1. Put a thermometer in the middle of the room at
1.5 Meter distance of the floor.
2. Wait 1 hour to be sure that your thermostat shows
the correct temperature.
3. Remove the setting button by pressing gently
outwards with a narrow screwdriver between the
button and the cover. (pay attention to avoid
setting button rotation)
4. Remove the internal wheel from the button. (in
grey Figure 1)
5. Put the internal wheel alone on the thermostat.
(Figure 2)
6. You can now put the setting button on the
thermostat, while marking corresponds real room
temperature (showed by the thermometer) and
thermostat indexer.
10