Technical Data; Rating Plate - AEG IKE64450IB Benutzerinformation

Problem
and a number come on.
You can hear a constant
beep noise.
8.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass

9. TECHNICAL DATA

9.1 Rating plate

Model IKE64450IB
Typ 61 B4A 04 AA
Induction 7.35 kW
Ser.Nr. .................
AEG
9.2 Cooking zones specification
Cooking zone
Left front
Left rear
Possible cause
The diameter of the bottom
of the cookware is too small
for the zone.
There is an error in the hob.
The electrical connection is
incorrect.
Nominal power PowerBoost
(maximum heat [W]
setting) [W]
2300 3200
2300 3200
Remedy
Use cookware with correct
dimensions. Refer to "Tech-
nical data".
Deactivate the hob and acti-
vate it again after 30 sec-
onds. If
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin-
ues, speak to an Authorised
Service Centre.
Disconnect the hob from the
electrical supply. Ask a quali-
fied electrician to check the
installation.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
PNC 949 597 269 00
220 - 240 V / 400 V 2N 50 - 60 Hz
Made in Germany
7.35 kW
PowerBoost
maximum dura-
tion [min]
10
10
ENGLISH 17
comes on again,
Cookware diam-
eter [mm]
125 - 180
125 - 180