AEG IKE64450IB Benutzerinformation Seite 16

16 www.aeg.com
Problem
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
Residual heat indicator does
not come on.
Automatic Heat Up does not
operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no sound when you
touch the panel sensor
fields.
comes on.
comes on.
Possible cause
You do not set the heat set-
ting for 10 seconds.
You touched 2 or more sen-
sor fields at the same time.
Pause operates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot because
it operated only for a short
time or the sensor is dam-
aged.
The zone is hot.
The highest heat setting is
set.
Power management oper-
ates.
The cookware is too large or
you put it too near to the
controls.
The sounds are deactivated.
Child Safety Device or Lock
operates.
There is no cookware on the
zone.
The cookware is unsuitable.
Remedy
Activate the hob again and
set the heat setting in less
than 10 seconds.
Touch only one sensor field.
Refer to "Daily use".
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the func-
tion.
Refer to "Daily use".
Put large cookware on the
rear zones if possible.
Activate the sounds. Refer to
"Daily use".
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware. Refer
to "Hints and tips".