Technical Data - Solar-Log Sensor Box Installation

Installation Manual Sensor Box
2.5 Starting Up at the Solar-Log
By switching-on the Solar-Log
Sensor Box. Afterwards, the Sensor Box must be configured
to the free RS485-port:
On the display, open the Config/Start/Initial config dialog box
In the inverter selection, tick the "M&T Sensor" box
Carry out the inverter detection
The Sensor Box is integrated with the system in the same way
as an inverter. The further configuration could be handled with
TM
the Solar-Log web interface.
2.6

Technical Data

Sensor Box
Dimensions, weight
Housing
Protection mode
Operating temperature
Power supply
Tolerance
Installation
Connection cable
Conformity
TM
TM
, it will provide power to the
W/H/D in mm: 145/85/40, 360 g
Metall
IP65
-20 °C to +70 °C
Via RS485 data cable from Solar-Log™
(12-28 V )
DC
Irradiance : ± 5% (0 W/m² to 1400 W/m² )
Cell-temperature: ± 1K (-20 °C to +70 °C)
with screws on the substructure
4-wire, 3 m
CE :DIN EN-61000-6-1:2007 and
DIN EN-61000-6-3:2007
TM
Solar-Log Sensor Box Installation | 9 von 28