Solar-Log Sensor Box Installation Seite 7

Installation Manual Sensor Box
When mounting the sensor, please take care that the cable is
mounted as seen in this figure.
2.3 Mechanical Installation Optional Sensors
The temperature sensor should be mounted with a wall brack-
et at a shadowy location. The 3-pin connector must be
screwed into the irradiance sensor.
The wind wheel should be mounted with the mounting angle at
the highest and most exposed location. The 2-pin connector
must be screwed into the irradiance sensor.
The cables of the optional sensors can not be extended.
2.4 Wiring the Data Cable with the Solar-Log
The Sensor Box is connected via the RS485 gateway with the
TM
Solar-Log . The 4-core connection cable between the irradi-
ance sensor and the Solar-Log
and 12 V power supply. A separate mains adapter is not
necessary.
TM
is used for data exchange
TM
Solar-Log Sensor Box Installation | 7 von 28
TM