Introduction - Fermax KIT VISIÓN DIGITAL Installationsanleitung

INTRODUCTION

The KIT VISION DIGITAL is an advanced Video Door Entry system for simplified
installation, specially designed to replace your old Audio Door Entry KIT by a new
Video system without changing the installation, in most cases. It is basically
made up of an Outdoor Panel, which will substitute the old audio panel, and a
Monitor installed in the place of the telephone. The Power Supply must be
substituted as well. In installations with small section of wires or long distances
between camera and monitor, an additional power supply may be needed.
VERY IMPORTANT NOTES:
Pag 20
The Outdoor Panel is protected against humidity
and atmosferical agents. In adverse conditions with
permanently hard rain or salty environment, it is
recommended to install the Panel with a hood or under
shelter. Strong light coming straight into the camera
(against the light) will produce contrast and/or
brightness losses.
To install the Monitor, choose a hard and flat
surface, far away from direct heat sources (radiators,
heaters, ...) or very smoky environments (kitchens,
etc.). We advise to install the Monitor in a place where
the call could be heard all inside the house.
The Power Supply should be installed on a hard
and flat surface, as inside the buiding as in the lobby,
etc... but always in inner places. It can be installed in
a DIN box for electric switches.
Generally, KIT VISION DIGITAL can be installed for
replacement of standard audio-door entry systems (5
wires), without changing the installation. However, in
installations with less than 0.25 mm
or distances longer than 25 m, an additional power
supply may be needed (see page 24 for details).
section of wires
2