Landing Gear Installation - Horizon Hobby Hangar 9 Timber 110 30-50cc Bedienungsanleitung

LANDING GEAR INSTALLATION

 This model can also use the sprung undercarriage from the Xcub
60cc (HAN526024). This optional undercarriage is substantially
heavier than the stock rigid undercarriage, and can detract
from the aerobatic performance. The mounts for the sprung
gear (and optional floats) are factory installed. All it takes is
the covering to be removed when these options are chosen.
1. Remove the windscreen from the fuselage by releasing the magnets
at the top and rotating it forward and off the fuselage. Remove
the landing gear cover from the fuselage exposing the slot for the
landing gear.
2. Secure the axle to the landing gear using a 14mm and 17mm box
wrench.
3. Prepare the four M4 x 20 socket head cap screws by placing an M4
lock washer and M4 washer on each of the screws. Place a drop of
thread lock on the threads of each screw.
4. Locate the two inner landing gear plates. The screws will thread into
the two holes indicated in the photo.
 Refer to checking the blind nuts on Page 6
before installing the screws.
Timber 110 30–50cc ARF
5. Make sure the inner landing gear plates are oriented as shown in
the photo. The gear has not been installed to show their installation.
6. Attach the landing gear to the fuselage using the screws and plate
from the previous steps. A 2.5mm hex wrench through the landing
gear mounting hole and fuselage can help guide the plate into
position Leave the hardware loose until all four screws are installed.
7. Use a 3mm hex wrench to tighten the screws securing the gear to
the fuselage.
8. Apply a drop of light machine oil on each of the axles.
9. Slide the wheel on the axle. The wheel is secured using the retaining
clip through the hole near the end of the axle.
13 EN