Tail Wheel Installation - Horizon Hobby Hangar 9 Timber 110 30-50cc Bedienungsanleitung

TAIL WHEEL INSTALLATION

1. Place the tiller arm on the bottom of the rudder with the leading
edge of the arm aligned with the rudder hinge line. Make the
locations for the mounting screws on the rudder using a felt-tipped
pen.
2. Use a drill and 1/16-inch (1.5mm) drill bit to drill the two locations
for the tiller arm mounting screws.
3. Prepare the holes by threading an M2 x 15 sheet metal screw in
each hole. Remove the screw and place a few drops of thin CA in
each hole. Once the CA has fully cured, use the screws and a #2
Phillips screwdriver to attach the tiller arm on the bottom of the
rudder.
4. Locate tail wheel assembly and leaf springs. The springs are
different lengths. The longer spring will fi t against the assembly, and
the short spring against the fuselage.
5. Remove the three M3 x 30 socket head cap screws and place a
drop of thread lock on the threaded end of each screw. Fit the short
spring, long spring, and assembly on the fuselage. Use the three
screws and a 2.5mm hex wrench to secure the springs against the
fuselage.
EN
6. Use pliers to bend the spring ends so the overall length is 4
(114mm). Prepare both springs.
7. Attach the springs to the rudder tiller arm. Wrap the loose end of the
spring around the main spring two or three times. Cut any excess
wire using side cutters.
8. Attach the springs to the tail wheel. Wrap the loose end of the spring
around the main spring two or three times. Cut any excess wire
using side cutters.
9. Repeat the previous steps to install the remaining spring.
 This model can also use the super scale heavy duty tail
wheel from the XCub (HAN526014). Please be aware this
assembly is heavier than the supplied tail wheel. Take this
into allowance when considering Center of Gravity.
12
1
/ inches
2