Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Maintenance
The Belle Group 'PCX' range of Single Direction Plate Compactors are designed to give many years of trouble free operation. It is,
however, important that the simple regular maintenance listed in this section is carried out.
It is recommended that an approved Belle Group dealer carries out all major
Group replacement parts, the use of spurious parts may void your warranty.
Before any maintenance is carried out on the machine, switch off the engine. If working on a petrol engined machine, disconnect the
HT lead from the sparkplug. If working on a diesel engine, make sure that the stop switch is in the stop position.
set the compactor on level ground to ensure any fl uid levels will be correctly read. Only use recommended oils (see chart on following
page).
Running In Period
When the compactor is fi rst used from new, the engine oil must be changed after the initial running in period (see engine manual for
full detail). The vibrator shaft case oil must be replaced after the fi rst 100 hours use, then after every 500 working hours. For detail on
vibrator shaft case oil replacement, see 'Vibrator unit'. The belt tension should be checked after 4 hours use.
Drive Belt
Remove the belt guard then check the belt tension by placing light fi nger pressure on the top of the belt, as near central between the
engine drive and vibrator pulley. The belt should defl ect by between 5mm and 10mm. If the belt tension requires adjustment, loosen
the four engine mount bolts enough to allow the engine to be moved. Adjust the engine's position by turning the tension bolt clockwise
to increase belt tension, anti-clockwise to decrease. Once set, retighten the engine mount bolts and check the belt tension a second
time. Finally, replace the belt guard ensuring it is correctly and securely fi tted.
Routine Maintenance
Engine Oil
Air Filter
Spark Plug
Drive Belt
Oil / Fuel Type & Quantity - Spark Plug Type
Gasoline Honda GX120
Gasoline Honda GX160
Gasoline Robin EX13
Gasoline Robin EX17
Diesel Hatz 1B20-6
Vibrator
Check Level
Change
Check Condition/Clean
Change
Tension
Oil type
Quantity
(Gals)
S.A.E. 10W 30
S.A.E. 10W 30
S.A.E. 10W 30
S.A.E. 10W 30
S.A.E. 10W 30
Turbine Oil 32
Vibrator Unit.
Remove the plug complete with seal, check that the oil level reaches the bottom thread on the oil
plug hole. Top up as necessary with the correct oil (see chart).

Servicing

maintenance and repairs. Always use genuine Belle
First 4
hours
Replace when necessary / Every 12 months
Fuel Type
0.15
Unleaded
0.15
Unleaded
0.15
Unleaded
0.3
Unleaded
0.23
Diesel
(BS2869)
0.1
N/A
23
First month / 3 Months
20Hours
50 Hours
Capacity
Spark Plug
(Gals)
Type
0.66
BM6ES or
BPR6ES
0.95
BM6ES or
BPR6ES
0.71
NGK BR-6HS
0.95
NGK BR-6HS
Refer to
N/A
Manual
N/A
N/A
Always
6 months
100 Hours
Electrode
Gap (mm)
0.7 - 0.8
0.6 - 0.7
N/A
N/A

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Pcx 400Pcx 450Pcx 500

Inhaltsverzeichnis