Compex SGX3226 Schnellinstallationsanleitung Seite 19

Upon powering up Compex SGX3226, the following LEDs will start indicating their status.
(Factory Default Configurations)
Types of LEDs
System Status
Redundant Power Socket
Mute
Power
Thermal Fault
Fan Fault
3. In order to connect network cables to Compex SGX3226, plug the network cable to RJ45
port of Compex SGX3226.
Note:
When connecting network devices through Ethernet cables, make sure that the right cables are
used so as to prevent malfunction.
4. The LNK/ACT LED of that particular port should light up to indicate good connection. If
not, check the cabling and connection of the devices again.
English
Status
Steady Green
Steady Red
Off
Steady Green
Off
Steady Green
Steady Red
Off
Steady Red
Off
Steady Red
Compex 24 Port 10/100 Mbps plus 2 Port Gigabit
Copper SNMP Managed Switch
SGX3226
Indication
In normal operation
Initializing or starting up
No RPS is installed or RPS is in Standby
Mode.
The alarm buzzer is disabled
The alarm buzzer is enabled
In normal operation
Power Fault occurs
In normal operation
Temperature is too high
In normal operation
Fans are not functioning well.
15