Expansion Module Installation; Removal Of Expansion Module - Compex SGX3226 Schnellinstallationsanleitung

2. After attaching both mounting brackets, position Compex SGX3226 in the rack by
lining up the holes in the brackets with the appropriate holes on the rack. Secure it to
the rack using the rack-mounting screws (8mm diameters) with a screwdriver.
Note:
For proper ventilation, do allow about at least 4 inches of clearance on the front and 4
inches on the back of the Switch. This is especially important for enclosed rack
installation.
3. Connect the power cord to the power socket on the rear panel of Compex SGX3226.
6.3.

Expansion Module Installation

A series of optional expansion modules are available for Compex SGX3226. As Compex
SGX3226 supports the hot plug function, you may install or uninstall the modules
without turning off the LAN Switch.
Please note that Compex SGX3226 is shipped with the Gigabit modules.
1. Insert the module carefully into the expansion module window and push it along the
module rail until it stops. Ensure that there is a secure connection to the PCB Board
of Compex SGX3226.
2. The Ready LED of the related port will light up.
3. Tighten the screws on the module.
6.3.1.
10

Removal of expansion module

1. Disconnect any cable from the module.
2. Unscrew and pull out the module slowly from the expansion module slot.
3. Slide the module completely out of the chassis and cover the slots with the
cover plate, screwing back using the original screws.
Compex 24 Port 10/100 Mbps plus 2 Port Gigabit
Copper SNMP Managed Switch
SGX3226
English