Setting Up Of Compex Sgx3226 - Compex SGX3226 Schnellinstallationsanleitung

3. Choose the COM Port which you have
selected from your PC.
4. Adjust the Port setting from the COM1
Properties screen. This will depend on
the console port that you are using.
5. Click OK to update the changes.
After setting all configurations, reset the
power supply of Compex SGX3226.

9. Setting up of Compex SGX3226

1. Plug the female end of the attached power cable into the primary power socket, which is
located at the rear of Compex SGX3226 chassis, and plug the other end into the nearby AC
power point.
Once the device is connected to the AC power supply, the Power LED will turn on
immediately.
Note:
For Redundant Power Socket (RPS), connect the AC main power to the Primary Supply first,
then to RPS.
2. After powered up, POST (Power On Self Test) will activate. The System Status LED will
turn RED during the POST. Once it has completed testing, System Status LED will switch
to GREEN and hence indicates Compex SGX3226 has been successfully set up.
14 Compex 24 Port 10/100 Mbps plus 2 Port Gigabit
Copper SNMP Managed Switch
SGX3226
English