Front And Rear Panel; Start-Up; Connection With The Sound Source - Omnitronic PMM-4 Bedienungsanleitung

4.2 Front and rear panel

5. START-UP

5.1 Connection with the sound source

This speaker-system is directly connected with the audio mixer. Connect the speaker-system via the Input-
socket and a standard microphone lead with a line level output socket of your mixer, sound-card etc.
Make sure that the power switch is set to "OFF". Before you connect the devices, all units have to be
switched off and the master-control is set to "0".
A good cable run improves the sound quality remarkably. Input cables should be short and direct, since high
frequencies will mostly be absorbed if the cables are unnecessarily long. Besides that a longer cable may
lead to humming and noise trouble. If long cable runs are unavoidable, you should use balanced cables.
In order to obtain highest sound quality, only use high-quality cables for connecting the devices. Make sure
that the cables are properly fixed.
20/24 11036460_V_1_0.DOC