Ryobi EID-100-2RE Bedienungsanleitung Seite 10

GB
F D
SPECIFICATIONS
Voltage
Chuck capacity
Drilling capacity
in wood
in steel
in masonry
Input
No load speed
high
low
Blows per minute
high
low
Weight
Safety class II
DESCRIPTION
A. Trigger Switch
B. Forward / Reverse Button
C. Keyless Chuck
D. Variable Speed Selector
E. Lock Button
F. Drill Mode Shift Knob
G. Depth Stopper
H. Gear setting button
I. Auxiliary Handle
J. Bit
K. Air Vents
L. Live Tool Indicator
M. Spindle Lock
STANDARD ACCESSORIES
Auxiliary handle, Depth Stopper and Drill Bit.
APPLICATIONS
(Use only for the purposes listed below.)
Drilling wood, materials and resin boards.
■
Drilling concrete (impact drilling only).
■
Drill metal: steel, brass, aluminum sheets, stainless
■
steel & pipe.
NOISE BUILD-UP
Noise (sound pressure level) in the workplace can
exceed 85 dB (A). In this case, sound insulation and hearing
protection measures must be taken by the operator.
E I P NL
110 V - 230 V ~ 50 Hz
13 mm (1/2")
40 mm
13 mm
16 mm
1050 W
0 - 2,880 min-
0 - 1,300 min-
0 - 46,080 min-
0 - 20,800 min-
3.2 kg
S DK N FIN GR
English
SWITCH (FIG. 1 & 3)
This tool is started and stopped by squeezing
■
and releasing the trigger switch (A).
The speed can be adjusted in either gear by
■
controlling the force applied to the trigger.
The maximum speed of the drill may be set at different
■
speeds by adjusting the variable speed selector (D).
For continuous operation, press the lock button (E)
■
while squeezing the trigger. Squeeze the trigger again
1
to release the lock.
1
CHANGING THE ROTATION DIRECTION (FIG. 2)
1
1
To change the direction of rotation, stop the tool and
■
push the forward / reverse button (B).
When the forward button is pushed in, the bit rotates
■
clockwise when viewed from the handle end of the tool.
When the reverse button is pushed in, the bit rotates
■
counterclockwise.
SPINDLE LOCK
For easy changing of the drill bit this drill is equipped with
an automatic spindle lock (M) which holds the spindle
stationary when loosening and tightening the chuck.
MOUNTING AND REMOVING THE BIT (FIG. 4 )
Insert the drill bit (J) into the chuck as far as the plain
■
part of its shank will go.
Tighten the chuck securely by rotating the chuck
■
head in a clockwise direction.
The bit can be removed by rotating the chuck in a
■
counterclockwise direction.
CHANGING BETWEEN DRILLING AND IMPACT
DRILLING MODE (FIG. 5)
The drilling mode shift knob (F) for changing between
the drilling mode and impact drilling mode is positioned
on the top of the tool.
DRILLING MODE: Shift the knob to the "
for rotation without impact action.
6
H CZ RUS RO
WARNING
Always be sure the spindle lock button is
released and the spindle lock is disengaged
before turning the drill ON.
PL SLO HR TR
" symbol