Technical Specifications - Beurer EM 30 Gebrauchsanleitung

gram denote how often you have already fully completed a program. These numbers are stored until
there is a battery change.
6. Cleaning
– Remove the batteries from the device each time you clean it.
– Clean the device with a slightly moistened cloth. In case of more extreme soiling you can also
moisten the cloth with mild soapy water.
– Never drop the device.
– Ensure that no water penetrates into the device. If this should ever happen then only use the
device once it is completely dry.
– Do not use any chemical cleaners or abrasive agents for cleaning.
– Once you have removed the device (operating unit), you can wash the belt in luke warm
water. Use mild soapy water or a liquid detergent for this purpose. Do not use bleaches.
– The belt is unsuitable for machine washing.

7. Technical Specifications:

Model:
Power supply:
Electrode size:
Parameter (500 Ohm load):
Pulse duration:
Waveform:
Weight:
Belt size for waist measurement from 70 to approx. 130 cm. (28 – 52 Inch)
Maximum permissible operating conditions: 0 °C to +40 °C, 20-65% relative humidity
Maximum permissible storage conditions:
Explanation of symbols:
Changes to the technical specifications introduced for reasons of updating without notice are reserved.
EM 30
3 x 1.5 V AAA (type LR 03)
approx. 10 x 10 cm
– Output voltage max. 70V p-p
– Output current: max. 140mA p-p
– Output frequency: 30 – 80Hz
200µs per phase
symmetrical, dual-phase square wave
~ 330 g
0 °C to +55 °C, 10-90% relative humidity
- Application part type BF
- Caution! Read the Instructions for Use.
1