Technical Specifications - Beurer EM 35 Gebrauchsanleitung

Avoiding unwanted pulse changes
To avoid inadvertently increasing the intensity of a training session, simply switch on the key lock.
Press the program selection key for around 3 seconds for this purpose (3). An acoustic signal
sounds and the "
once more.
Reacting to unpleasant sensations
If you feel prickling or itching on your skin even if, at this stage, you only notice a tingling and not
muscle contraction, you should switch off the device and proceed as follows:
– Check whether the electrodes are OK or if they are defective.
– Check whether the round cover over the electrode connections is still in place.
– Take the belt off and completely moisten it again.
– Ensure good skin contact and good moistening the next time the belt is applied.
Taking a break during the training session
If you wish to take a break during a program, briefly press the Pause key. An acoustic signal sounds
and the pause symbol "II" symbol appears on the display. By pressing the key again you can conti-
nue the program.
Reading off the number of training sessions
You can read off the number of your training sessions on the display. The numbers after the pro-
gram denote how often you have already fully completed a program. These numbers are stored until
there is a battery change.
6. Cleaning
– Remove the batteries from the device every time you clean.
– Clean the device with a slightly moistened cloth. In case of more
extreme soiling you can also moisten the cloth with mild soapy water.
– Never drop the device.
– Ensure that no water penetrates into the machine. If this should ever happen, only use the
machine again once it is completely dry.
– Do not use any chemical cleaners or abrasive agents for cleaning.
– Once you have removed the device (operating unit), you can clean the belt with a damp cloth. Use
mild soapy water or a liquid detergent for this purpose. Do not use bleaches.
– The belt is unsuitable for machine washing.

7. Technical Specifications:

Model:
Power supply:
Electrode size:
Parameter (500 Ohm load):
Pulse duration:
Waveform:
Weight:
Belt size for waist measurement from 75 to approx. 140 cm.
Accessories:
Maximum permissible operating conditions: 0 °C to +40 °C, 20-65% relative humidity
" symbol appears on the display. To deactivate the key lock press the key
EM 35
3 x 1.5 V AAA (type LR 03)
approx. 11,3 x 6 cm: 7,8 x 9,7 cm
– Output voltage max. 70V p-p
– Output current: max. 140mA p-p
– Output frequency: 30 – 80Hz
200µs per phase
symmetrical, dual-phase square wave
~ 330 g
belt extension 40 cm
14