Stand Assembly & Adjustment - Vornado 133-EU Betriebsanleitung

STAND ASSEMBLY & ADJUSTMENT
(MODEL 683)
No tools required.
STAND ASSEMBLY
1. Insert power cord (A) into
the top of Pole and pull
through the bottom.
2. Push the Circulator Head
into the Pole. Push until
the Lock Release Button (B)
snaps through the Hole (C).
3. Remove the Fastening
Nut (D) secured on the
underside of the base.
Rotate Fastening Nut
counter-clockwise to
remove.
4. Assemble Legs onto the
base of Pole by pushing
each Leg onto the grooves
(E). Replace Fastening Nut
(D) by rotating clockwise to
secure all the Legs in place.
10 English
B
C
A
D
E
HEIGHT ADJUSTMENT
(32 - 38 INCHES)
1. Support the Circulator Head
(A) with one hand. Use your
other hand to loosen the
Adjustment Collar (B) by gently
rotating it counter-clockwise.
A
2. Slowly raise or lower the
Pole to the desired height
and secure into position by
rotating the Adjustment Collar
clockwise until tight.
Note: Before adjusting the
height or rotating the head,
check that the power cord is
not tangled and able to move
B
freely.
After adjusting height, ensure
that the Adjustment Collar is
fully tightened and engaged to
ensure Circulator Head does
not rotate and bind power
cord.